The scan glass surface inside the ADF becomes hot during ScanSnap operation. Clean the inside of the ScanSnap according to the following procedure. For example, the inside of the ScanSnap must be cleaned more frequently when scanning documents with loose toner. Note that this guideline varies according to the type of the documents you are scanning. As a guideline, clean the inside of the ScanSnap every 1,000 scans. In an alternating succession of scanning documents, the accumulated paper-powder and dust inside the ScanSnap causes a scanner error. Sparks, caused by static electricity, generated when blowing off dust and dirt from the outside of the scanner may cause a fire.Ĭlean inside of the ScanSnap with a cloth moistened with Cleaner F1. This may cause the ScanSnap to fail, malfunction or scanning errors. Dust blown up by strong air from the spray may enter inside of the ScanSnap. Rack2-Filer V5.0 (Note1)(Note2) System Requirementsįor details on how to buy cleaning tool, please contact the Fujitsu scanner dealer where you purchased your scanner.ĭo not use aerosol sprays near the scanner.ĭo not use any aerosol sprays or alcohol based sprays to clean the ScanSnap. * The system requirements may change depending on the duration of support and the support policy of the companies that make the software listed in the table above. Scanning speeds may drop if the recommended CPU, memory capacity and USB 1.1 requirements are not met.The ScanSnap device may not work if the connected computer does not meet these requirements. Please refer to the " Software Downloads" for latest support information.
0 Comments
Leave a Reply. |